Flanges are available in lengths of 1 1 1 1.
Z bar flashing installation.
Steel z bar flashing with 2 in.
The seat dimension 3 8 in corresponds to the siding thickness.
The z bar is available in 018 033 043 054 thickness of steel.
Item 3807 model 5504900120.
Z bar design easily accommodates rigid insulation.
If only the surface is damaged.
Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver.
Place the z flashing into position on top of the casing.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
Designed for roofing applications.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Check out our recommended tools right here.
Install the first length of z flashing.
How to install z flashing on rotted t1 11 siding 1.
Backleg made of 28 gauge galvanized steel.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
It is used to protect the horizontal joints between sheets of siding from water infiltration.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Suitable for residential or commercial use.
Galvanized steel unless specified.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
Thd sku 686080.
